Put one of New Holland’s five T9 Series SmartTrax™ tractors to work for you and you get the benefit of 2,800 square inches of ground contact per track module for a total footprint of 11,200 square inches. That maximises traction, flotation and ride smoothness, while reducing ground pressure and compaction for minimal surface damage, and that improves soil fertility and water drainage, maximising your yields.
The next generation of tyre solutions comes with Low Side Wall technology — powerful, rugged, balanced, and power hop resistance all wrapped up in a single tyre solution. While increasing the rim diameter but not increasing the tyre diameter, a lower side wall results in a tyre with more stability for heavy pulling and roading applications and high ground area contact — yielding more productive results for your operation.
Tailor your dual or triple tyres to your operation, whether it’s roading, heavy pulling or row crop applications. Highflotation duals feature an IF rating that produces a stronger tyre to carry heavy loads at lower tyre pressure. This results in less compaction and fuel usage. Row crop applications require the proper tyre to decrease compaction and maintain traction throughout the tyre’s lifetime, all to improve yields year after year.
New Holland SmartTrax II gives your T9 Series tractor the lightest footprint
and the heaviest pull, resulting in the ultimate-productivity tractor.
SmartTrax II is a choice that best suits your terrain, your applications and
your budget.
1. The largest drive wheel in the industry measures a
massive 56.3 inches in diameter — that’s 30% larger
than the nearest competitor
2. 13 to 14 drive lugs are fully engaged at all times,
eliminating slippage between the drive wheel and
track. This also reduces the load per lug compared
to other designs, which increases belt durability.
More power is transmitted through more drive lugs
for better power distribution and extended track life
3. The axle position of the SmartTrax II design results
in a low centre of gravity, which improves total
vehicle stability
4. Designed with no mid-roller directly under the track
module pivot point to reduce over-centre ride impact
for maximum operator comfort
• All bearings are sealed and lubricated for a lifetime with
annual maintenance
• No daily greasing as there are no grease fittings
• Check the bogey and idler wheel oil levels only once a year
and change at 5,000 hours
• No need for complex alignment adjustment mechanisms
that need to be adjusted, serviced, and replaced.
The SmartTrax II rigid undercarriage shaft bores are
machined in one operation to ensure excellent alignment
between bores, plus New Holland uses straight steel
cables in the heavy-duty belts
New Holland T9 Series tractors can now be equipped with Low Side Wall (LSW)
tyres to meet the new demands of producers looking for high flotation, heavy
pulling, and a narrow overall package for roading applications. LSW tyres feature
the ability to maintain high load ratings at 40% lower inflation psi values, opening
new productivity value to a single tyre combination. The larger rim diameter —
without increasing the overall LSW tyre diameter — results in a more stable tyre
for the toughest applications.
When equipped with LSW1250/35R46 singles, the overall width measures about
150 inches or 12.5 feet. This narrow roading width, in combination with a light
footprint, provides a middle ground when choosing between SmartTrax and
high-flotation duals.
Low Side Wall tyres design features a larger rim diameter without increasing the
overall tyre diameter, providing more stability for heavy pull and roading applications.
As the aspect ratio of a tyre increases so does the chance for bouncing during
roading and power-hop in in-field heavy pull applications. LSW tyres eliminate
those chances with a lower aspect ratio.
With LSW singles, total psi on the ground is comparable to high-flotation duals on
tractors with similar gross vehicle weight — but yields a nearly 20% reduction in
overall tyre width.
New Holland T9 Series tractors utilise the Row Crop frame on models up to the T9.560. When used in combination with VF Row Crop tyres, they maintain load carrying capacities at lower air pressure ratings — producing less compaction, less fuel consumption to promote bottom line returns. High flotation duals can also be equipped with this technology, further improving fuel consumption in heavy-pull applications. Triples distribute the overall weight of the T9 Series tractor over even more area, decreasing compaction for your specific application.
Spring Implements, planting, post emergence side-dressing, grain carting, roading, and fall primary Implements—there is no application that the T9 Series tractor can’t handle.
Heavy-pull applications call for the High Power Frame matched with highflotation tyres. Tyre designs featuring improved traction capabilities are made for these kinds of applications. Grain cart applications with VF dual tyres (Row Crop Frame shown) allow for high-speed, low-pressure inflation, which lessens soil compaction while boosting fuel economy. Through less compaction, the T9 Series tractor improves your harvest and yields the following year.